Railroad Ties Retaining Wall

Cut any excess off one end of a railroad tie to fit your area if needed.

Railroad ties retaining wall. With railroad ties you should use a 4 foot length of a tie that goes straight into the hillside and is also resting on the wall itself. See prop 65 warnings. Unlike stone or masonry retaining walls retaining walls made of railroad ties do not weigh enough to retain soil without proper modifications. November2017 at 12 13 am reply.

Treated wood railroad tie can be used to add an attractive natural looking touch to your landscape project. They are especially useful for building raised flower or garden beds and in terracing hillsides. Railroad ties rot from exposure to water requiring you to replace the ties. Diy retaining wall retaining wall from railroad ties build.

Treated wood provides a natural look and longevity to a landscape s design. Make sure your ties are sitting flush on the ground by setting a level on them periodically throughout the length of the wall to check. How to repair railroad tie retaining walls dig out the dirt sitting within 3 feet of the retaining wall using a shovel. Cut the area to make a snug fit for the railroad ties you want to cut the area where the wall will be square so the ties fit in there nicely.

Lay the first set of railroad ties out along the prepared ground making sure the ends fit snugly together. Wooden timbers and railroad ties are popular choices for creating alternatives to retaining walls. When building a retaining wall out of any material and especially with railroad ties you must have some sort of tie between the wall and the ground it is holding back. Remove any ties that are spongy cracked or crumbling on any side.

It is typically 7 in. Over time the homeowner s wooden retaining wall had deteriorated. A railroad tie retaining wall is made up of rows horizontal lines of the treated wood. Installing deadmen in the retaining wall helps anchor it since the ends of the deadmen are anchored by the weight of the soil above the deadmen.

See more ideas about railroad tie retaining wall retaining wall landscaping retaining walls. When a railway company replaces its sleepers it pulls the old ones and replaces them with new ones. Reposition the railroad ties so they sit in a slight step configuration if they are stacked straight up with an offset of 1 inch. Installing deadmen in the retaining wall helps anchor it since the ends of the deadmen are anchored by the weight of the soil above the deadmen.

Make the area about 5 or 6 inches deeper than the railroad ties so you have room to fill the area behind the tie wall with gravel.