Paste Wax Over Polyurethane

Move the pad in smooth horizontal motions so you can apply an even coat of wax to the surface.

Paste wax over polyurethane. Should i apply wax over polyurethane. Paste wax is best used as a polish over an existing finish such as lacquer varnish shellac polyurethane or even oil finishes. Minwax paste finishing wax function. Apply a wax finish over top of the poly and buff but don t buff to a high gloss.

Brush on three thin coats with a foam brush. Wax soften soften in direct sunlight or near heat so you do need to be careful not to place furniture in direct sunlight or next to radiators. Oiled wood floors are another matter they require the protection of a surface coating which helps lock out moisture and give the wood a sheen. Flooring professionals generally don t recommend applying paste wax to a polyurethane floor finish.

Work in short smooth motions until there are no visible scratches in the polyurethane. I want to do a coat of paste wax over the poly on the tabletop but i ve heard that you should wait for the poly to fully cure before applying wax on top of it. A more practical use for paste wax for today s modern woodworker is to use it over an existing polyurethane varnish shellac or lacquer finish to give a piece an unmatched luster and shine. Wax has a soft sheen and buttery smooth finish.

Allow each coat to dry fully. Polyurethane doesn t need the extra protection and applying wax may make the floor dangerously slippery. You can use a natural bristle brush with oil based poly but keep an eye out for loose brush hairs coat the entirety of your workpiece but don t brush excessively or you ll create areas with too little polyurethane. Wax doesn t harden to the capacity that polyurethane does although it does protect furniture.

If you are a newbie to this type of method minwax paste has the ability to revive what was once worn without the tedious effort of removing the polyurethane layer. You can also use a section of 0000 steel wool to buff the surface. Give your glossy minwax poly a light sanding tack clothe clean and then apply a few coats of flat or semi gloss poly over top. This will piece will hold stacks of plates wine glasses etc.

Hi i just stripped an old china cabinet used a water based stain and finished with an oil based polyurethane. This will cut down on the gloss. I ve heard anywhere from 24 hours to a week for this cure time and i just wanted to get r woodworking s thoughts on the subject. As mentioned it will give you a little extra protection against scratches but most modern finishes like polyurethane and newer lacquers and varnishes are very hard to begin with and usually the finish alone is abrasion resistant enough.

I am concerned that the pressure from the stack of plates will cause the bottom plate to stick such that i will need to pry it off. Add a pea sized amount of car paste wax to a polishing pad or cloth.